loading

Fusai - Trusted Trailer Parts Manufacturer and Supplier Since 2003

Causes of the brake deflection

??Even if it is only used normally, after a long time of use, the braking effect of the brake will also deviate, so what are the reasons that cause the brake to deviate?

????① If the vehicle runs off during normal driving, first perform the following visual inspection: check whether the tire pressure, pattern, and wear of the left and right wheels are consistent; check whether each shock absorber is leaking or fails; check whether the suspension spring is broken or Whether the elasticity is consistent.

????② Support the wheel, turn it by hand and push and pull the wheel tire axially. If there is looseness or over-tightness on one side of the wheel, the pre-tension of the bearing should be readjusted; if there is a card issue or abnormal noise when turning the wheel, check whether the wheel hub bearing is damaged or damaged.

????③ Car road test. After braking, if the car deviates to one side, the wheels on the other side are not well braked.

????First deflate the wheel brake. If no brake fluid is sprayed out, it means that the wheel brake line is blocked and should be replaced. If there is air in the released brake fluid, it means that air is mixed in the brake line of the wheel and it should be discharged.

????Observe the wheel brake clearance. If the brake clearance is too large, it means that the brake shoe friction plate is worn seriously or the brake self-adjusting device fails, and it should be replaced.

????The above inspection is normal, and the wheel brake should be removed and inspected. Check whether the brake disc or brake drum is worn or even grooved, if it is too worn, it should be replaced; if there is severe groove, it should be turned or bored; check whether the brake shoe friction plate (friction pad) is oily or dirty Water is wet and worn too much. If the friction lining (lining) is oily or wet, the cause should be identified and cleaned up; if the friction lining is too worn, it should be replaced; check the brake wheel cylinder or caliper piston if there is oil leakage Or card issue, it should be replaced.

????④ If there is a deviation from side to side when braking, check whether the front wheel alignment meets the requirements. Should be adjusted; check if the steering gear is loose, if it is loose, tighten, adjust or replace it.

????⑤ If the vehicle flickers during braking, check whether the load sensing proportional valve is faulty.

GET IN TOUCH WITH Us
recommended articles
200 FAQ INFO CENTER
Technical status of dynamic platform car axle will directly affect the various properties of the car, therefore, for the power car axle according to regulations for maintenance, the maintenance of the mileage and team failure to timely diagnosis and elimination.
Small make up to introduce today is about some of semi-trailer hydraulic leg failure analysis, everyone understands this, in the later when the leg problems also need not worry too much, so the specific look at together: (
1)

Semi-trailer oil leak was due to a loose connection, should find the place, tighten the;
Seal is damaged, should be replaced;
Have crack line, should be replaced or weld repairs.
Lianyungang huayang machinery manufacturing co.
Common axle type mainly has: the external type brake drum series, the series of built-in brake drum, spoke type wheel series, the series of low bed series, type axle, American axis tilting axis.
Hydraulic trailer axle, dynamic platform car axle and wheel handle locomotive bridge is my company's main products, from the general customers trust in the industry, the quality of our trailer axle is good, but it is not easy, in the use of trailer below give you an overview of the trailer axle transmission should pay attention to three points!

Transmission of maintenance is very important, trailer is not exceptional also, especially during the period.
First, expert proposal, the owners can launch about half a minute in semi gear drive, and then drive after normal operation, extend the time of the vehicle in the winter.
Sometimes have to say that people are really smart, know how to save yourself, electric truck can be said to be many factories are an essential part of.
A, remove 1 of semi-trailer axle, lifted vehicles, remove the front wheel.
Axle function is passed between frame or frameless body and wheels and the direction of forces generated by the bending moment and torque.

As a rapidly developing trailer parts provider, our company now covers an area of 20,000 square meters, and has more than 150 employees.

contact us

Contact Person: Mr. Huawei Wang
Tel: +86-13356687529 / +86- 15753112927
 / +86-13280015673
E-mail: whw@sdfhcheqiao.com
Fax: +86-531-83828182
Address: Nanwang Industrial Park, Xianggong Town, Zhangqiu City, Shandong Province, China 
Copyright © 2026 Shandong Fuhua Axle Co., Ltd. | All Rights Reserved | Sitemap
Contact us
wechat
whatsapp
Contact customer service
Contact us
wechat
whatsapp
cancel
Customer service
detect